This switch performs the same function but the lid must be locked in place for the machine to wash.
Washer lid locks then unlocks.
If i press fill while the lid is up the washer will fill just fine but as soon as i close the lid again it will just lock and unlock again.
Door lock motor and switch assembly.
Pausing the wash cycle is how it can be disabled.
Once the washer door is closed the washer can begin operating.
This switch is connected to a solenoid that completes a circuit allowing the machine to run only if the top is down.
Pausing the machine will allow you to open the lid.
110 26002012 washer when i push start the lid locks and it spins then it unlocks and does nothing.
Add any extra garments into the washing drum at this time if necessary.
If it still won t budge proceed to plan b.
If the door lock is defective the washer door will not latch properly.
Check lid lock mechanism for obstruction or binding.
However some washing machines come with a lid lock.
Models without precise fill only lock during the spin cycle.
The door lock secures the washer door shut during operation.
Ge washer keeps locking and unlocking i tried to start a load this morning but it just keeps locking and unlocking once i close the lid.
To unlock the lid.
The lid lock mechanisms on some washers are heat activated which means overriding them is as simple as letting them cool off.
Most washing machines come equipped with a lid switch.
The lid lock is a default feature of your maytag front loading and top loading washer to prevent opening the appliance while the cleaning cycle is in progress.
Push the start stop button to unlock the washer door during the spin cycle.
Main control cannot determine if lid lock is in a locked state.
Inspect the door lock for damage.
Perform the following checks if the washer does not lock or unlock.
The door lock can fail either mechanically or electrically.
Perform the lid lock test under manual test mode on page 9.
The following steps assume that this step was unsuccessful.
If it opens you re all set.
After a few seconds the washer will halt and you ll hear the door unlocking.
During the spin cycle pausing the washer does unlock the lid but you must wait until the basket has completely coasted down to a stop before the lid unlocks for safety reasons.
The lid lock latch switch does three things.
1 it tells the control board the lid is closed 2 it locks and unlocks the lid 3 it tells the control board that the lid is locked.
