Inspect the door lock for damage.
Washer won t drain or start.
If the door lock is defective the washer will not spin or start.
Instead the direct drive top load washer stops if you lift the lid.
If the washer won t drain the lid switch assembly might be defective.
The lid switch assembly can fail either mechanically or electrically.
And the washer will not drain properly.
If the washer won t drain should check the drive belt.
A few different factors could be at work if your washing machine fails to drain at the end of a wash cycle.
Why won t my washing machine drain.
For cost appliance par.
Washing machine not draining.
This is a very common problem.
Won t drain after the wash cycle ends and before the spin cycle starts the water should drain from the washer.
The wash cycle won t start if the direct drive washer doesn t fill or the water level pressure switch doesn t detect that the washer filled.
If you need to fix a clogged washer that won t drain start by pulling the washing machine out from the wall and removing the drain hose from the back of the washer.
Start by unplugging the machine and.
If the washer won t drain or spin either something is stuck in the washing machine drain hose or pump or the pump is broken.
5 minute zip tie repair of the lid switch gets your washer working again in minutes just need a phillips screw driver and a zip tie visit our website ht.
Then run a plumber s snake through the drain hose to clear any clogs that might be trapped.
The lid switch confirms that the lid is closed allowing top load washers to proceed with various stages of the cycle.
The door lock can fail either mechanically or electrically.
If a washer won t drain or spin the fix is simple if you re even just a little bit handy with tools.
Wait until the drain cycle is complete and try starting your dishwasher.
If you can see the item clogging the drain grab it with pliers and pull it out.
If water remains first check for a kink or clog in the drain hose a backup in the house drain system or in a drain hose lower than the water level in the drain tub.
If this switch malfunctions you may be.
If the washer won t drain or is not draining properly and the washer has a coin trap remove the coin trap and clean it thoroughly.
While pressing the start button once starts the cycle pressing it again resets the dishwasher and runs a drain cycle for 90 seconds.
This type of washer doesn t lock the lid because it spins the basket at lower speeds than a vertical modular top load washer.
