Only the ratio of hot to cold.
Water heater mixing valve problems.
The cold and hot mix points are prone to liming up.
The problem is what you suspect.
You are going to need to divert the hot water feed 1 and the cold feed 2 to the water heater through the thermostatic valve 4.
This way if a child or elderly person finds themselves in a situation where they re in the bathtub with only the hot water on they.
The mixing valve is on the back of the water heater and mine has a red knob.
At such times mixing valve troubleshooting is necessary.
Sometimes when mixing valve problems arise it can lead to complications with the water flow or water pressure.
Hence to be able to troubleshoot mixing valve problems and to obtain answers experts can provide the information needed quickly and affordably.
The problem with these valves is that they don t sense the temperature.
Not hot enough for showers or doing dishes.
Atwood has tried to make the valve tamper proof.
Therefore if you turn the valve all the way to hot water comes out at the same temperature as a water heater that was set too high.
The problem was the mixing valve.
The mixing valve ball may not be seated properly in the valve s stem and water is escaping.
The shower drips if the water is completely turned off and warm water is dripping from your shower head then it could be that your hot water mixing valve has a problem.
In this video we ll walk through removing and.
One for the volume of water and one for temperature.
I urge you to try and carefully remove the guts of the mixing valve and clean it in white vinegar with a toothbrush.
Plus labor at the dealership.
Replacing the mixing valve is the best solution.
The thermostatic valve has a cold water inlet a hot water inlet and an outlet with water at the required temperature which you can set and lock on the valve.
To solve this problem the hot water heater is kept at a higher temperature and when you open a faucet the mixing valve will add a little bit of cold water to cool down the hot water we receive at the fixture.
That point is typically in the mixing tempering valve.
That lime is from water hardness and it collects when heated to a certain point.
