Originally it had a ratio of copper and nickel and was labeled a coppel copper nickel element.
Water heater thermocouple tester.
Thermocouple thermometer 50 300 degree industrial temperature meter j k t e n r s type thermocouple dual channel temperature meter tester lcd backlight 3 9 out of 5 stars 7 22 99 22.
In the early 1900s honeywell applied it to the safety gas valve.
Acceptable range for most water heat.
Light the pilot by pressing and holding the pilot light button on the gas control valve.
A gas water heater in boise baton rouge buffalo or boston uses a thermocouple that includes a probe attached to a copper tube that screws into a port on the gas valve.
Pilot light keeps going out.
If the pilot light doesn t stay lit check the gas water heater thermocouple by keeping the pilot button depressed.
A faulty thermopile may be at fault.
Thomas seeback discovered it in 1821.
Thermocouples designed for residential gas appliances such as fireplaces water heaters and furnaces are made for 30 millivolts.
Discretion should be used if the reading is between 21 and 25.
The reading should be between 25 and 30.
Measure the current by using the multimeter device set on millivolts.
How to test a thermocouple.
To make certain the thermocouple is bad you have to test it.
For testing a thermocouple you first have to remove it from the furnace water heater or gas appliance where it is installed.
The water heater thermocouple is a device that monitors temperatures in the water heater to determine whether it needs to heat up or turn off the heat.
How to test a thermopile s voltage using a multimeter.
It is comprised of two different types of metal which react differently to heat and expand at different rates signaling to the water heater when to turn on or off.
One probe of the meter should be connected to the copper sheath of the thermocouple and the other to the gas valve.
Once it is removed you will need a multimeter that needs to have the ability to read millivolts and a source of fire.
Usually a lighter will suffice for the test.
Here s how to test a suspected thermocouple in a gas operated water heater.
If the thermocouple is working you should be able to measure 30 to 40 millivolts of voltage at the connection end of the tube when the pilot flame is on.
