Water Shut Off Valve Stuck On Pipe

Turn off the next valve up the line which may be the main water supply valve.

Water shut off valve stuck on pipe.

Deburr the pipe with a deburring tool. Clean and prep it s a good idea to shut off the water supply before you try to bully a valve into submission. Before you try to loosen a stuck valve with brute force consider following these three simple steps. When you find that you have a pvc ball valve that just doesn t want to budge try these three steps to loosen it.

Place a bucket under the old valve. This tip if followe. Attempt to loosen the valve by opening and closing it several times by turning its handle. Pex supply lines can use shut off valves with barbed compression or push to connect ptc fittings.

Not knowing how to free stuck plumbing valves though can lead to broken valves pipes and fixtures leading to more expensive repairs. Open the faucet to drain the line. Shut off the water at the main shutoff valve. Then open a faucet on the lowest level of your house and another faucet on an upper level to drain the pipes.

The types of water shut off valves connect to supply lines in different ways often dictated by the material of the connecting pipe. First you will need to turn off the water supply to your home at the main shutoff valve. Then give the ball valve a try by hand. First make sure that you shut off the water that supplies the valve you re going to be working on.

Loosen your pvc ball valves with these easy steps. This is usually caused by the rubber. Shut off the circuit breakers to an electric water heater. Of course you won t find out until you need to shut off the valve to make a repair on a pipe line sink or bathtub.

Here is a video showing you how to handle a situation in which the water shut off valve or angle stop does not want to close or shut off. If you have a gas water heater turn the knob to the pilot position. If you ve found that one or more of the water valves in your house have become stuck here are some tips you can try to loosen a stuck water valve. Cut the supply line with a pipe cutter leaving enough room between the escutcheon plate and the cut to allow installation of the valve fitting.

Have you ever tried to turn off the water to a sink or a running toilet only to find that the valve is stuck in place. Water shut off valves tend to accumulate mineral residue and freeze. Otherwise you ll find yourself dealing with a gusher if the valve cracks or the pipe breaks. Then disconnect the supply tube from the shutoff valve.