The recharge phase involves placing sodium ions into the saturated hard water.
Water softener flush cycle.
A strong salt water brine solution is created with the salt added to the softener.
Recharging consists of five stages.
You can manually set the water softener to perform an extra backwash and fast rinse cycle before the normal regeneration.
Backwash 10 minutes this step removed accumulated dirt and such while also fluffing up the media bed.
This is known as the water softener backwash cycle.
Water softener 5 recharge regeneration stages.
The following steps are involved with regeneration.
All the oxidized iron that has settled to the bottom of the tank gets stirred up and rusty dirty cloudy water will show up immediately after a regeneration for a day or so.
During a backwash of a water softener system water runs through a resin tank upward.
Once every few months pour water softener cleaner into the brine tank following label instructions.
This helps keep the resin efficient and functional.
It does this at a fast speed and flushes iron minerals from the resin bed and out to the drain.
Water softeners regenerate by removing trapped contaminants and replacing them with either sodium or potassium depending on which chemical you put in the brine tank.
In the backwash phase the dirt inside the mineral tank which translates as residue from the previous regeneration process is flushed out through the drain and outside the water softener.
Fill brining brine rinse backwash and fast rinse note.
The times for each of these stages are variable and change just.
During regeneration the backwash cycle reverses the flow of water in the softener tank to lift loosen the resin bed and flush the gravel bed at the bottom of tank.
Put two cups sterilizer into the brine tank run two or three regeneration cycles then flush your pumping.
Manually start a regenerating process or pour in the cleaner right before a scheduled regeneration.
Here are the typical water softener regeneration steps.
To exclude this possibility sterilize your system with chlorine or hydrogen peroxide.
Depending on the size of your water softener a regeneration cycle typically takes about 30 to 60 minutes and uses anywhere from 40 to 60 gallons of water.
No softened water will be available for home use until the regeneration cycle is complete.
Flush with water softener cleaner.
So when a water softener runs it is in its regeneration or backwash cycle during which the softener pumps water into a salt tank to make brine then flushes the brine backwards through the water treatment tank then flushes the brine out of the treatment tank.
However the accumulation of bacteria in your softener may also be a cause of undrinkable brown water.
