Push the valve to the bypass position then turn off power to the water softener.
Water softener valve operation.
Isolate the water softener.
Now the water is flowing past the softener and not through it.
Water softener costs vary widely depending on the size and make of the softener but expect to pay between 2 000 and 2 500 for a typical system including installation.
When you add salt the salty liquid from the brine tank washes away the hardness ions replacing them with a fresh layer of sodium ions.
Use of this water softener.
Over time the water softener tank fills up with hardness ions and can no longer soften the water.
Using a water softening syst.
Sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
The water softener system resumes softening the water.
Every culligan water softener that we install has a bypass valve.
This valve allows the water to bypass the softener should you have a problem.
How does a water softener work.
This can be done by a specific valve called the bypass valve.
Find out in this video.
Simply rotate the knob in a clockwise direction up to the point where the two knobs on and off lock into each other unlike during normal operation.
One can be traced to the inlet and the other would be softened water flowing to the rest of the house.
Examples of issues are.
The water that you use every day can be hard on both you and your house.
Bypassing your culligan softener can create a temporary fix until a service technician can repair the problem.
Softener manufacturers supply a bypass valve.
Turn both outer valves off by rotating clockwise.
Operation this appliance can be used by children aged from 8 years and above and persons with reduced physical.
If your water softener has a manual bypass valve photo at page top and sketch at left you can temporarily take the water softener out of operation that is you can put the the valve into bypass position so the water softener is not in the piping loop at all.
Then turn on the center valve by rotating counter clockwise.
Softened water contains trace amounts of salt.
It is found on the control at the back.
To locate the bypass valve look for two pipes that are connected to the water softener.